6DD1683-0CC0 SIEMENS 电源设备

 技术描述：

跳线J17是模拟输出跳线。该跳线选择0-10 VDC或
4-20 mA缩放信号输出，可编程成比例的速度
或扭矩使用参数P.012。请参考《GV3000/SE软件启动指南》
有关此参数的更多信息，请参考手册。
跳线只选择0-10 VDC源电压或4-20 mA汇聚电流到
表示速度或扭矩。请注意，4-20 mA电流选择需要电源
供运行的电源如表7.3和7.8所示，端子10和11。

稳压器板上的端子带提供连接客户的端子
I / O设备。参见图2.9、2.10、2.11和2.14。以下终端是
提供:
•终端1-3:RS-232连接
•端子4-9:编码器连接
•端子10-11:模拟输出连接
•端子12-15:模拟速度/扭矩参考连接
•端子16-25:24V DC数字输入连接
•端子26-27:缓冲电阻制动控制连接
(仅限1-10 HP调节器板)用于较旧的缓冲器电阻制动套件
(如M/N 2DB4010系列)
•端子28-31:状态继电器连接

Technical description:

Jumper J17 is an analog output jumper. The jumper can be 0-10 VDC or
4-20 mA scaled signal output, programmable to proportional speed
Or torque usage parameter P.012. For details, see GV3000/SE Software Startup Guide.
Refer to the manual for more information on this parameter.
Select only 0-10 VDC source voltage or 4-20 mA convergent current to the jumper
Represents speed or torque. Please note that the 4-20 mA current selection requires a power supply
The power supply for operation is shown in Table 7.3 and 7.8, terminals 10 and 11.

The terminal band on the regulator board provides terminals to connect to the customer
I/O devices. See Figures 2.9, 2.10, 2.11, and 2.14. The following terminals are
Provided by:
• Terminal 1-3:RS-232 connection
• Terminals 4-9: encoder connection
• Terminals 10-11: analog output connection
• Terminals 12-15: Analog speed/torque reference connection
• Terminals 16-25:24V DC digital input connection
• Terminals 26-27: Buffer resistance brake control connection
(1-10 HP regulator boards only) for older buffer resistance brake kits
(such as M/N 2DB4010 series)
• Terminal 28-31: Status relay connection

其他型号推荐：