IS420UCSBH1A GE Mark VIe、EX2100e 或 LS2100e 控制器

产品描述
is420ucsh1a控制器是通用电气制造的第 一个UCSB控制器，是Mark VIe控制安全系统系列的一部分。该控制器类似于UCSC控制器，虽然它没有相同的硬件，但操作该控制器所需的软件几乎相同。根据GEH-6725 Mark VIe和Mark VIeS，控制设备HazLoc指令指南IS420UCSBH1A控制器被标记为Mark VIe, LS2100e和EX2100e控制器。这个控制器还有一个特定的微处理器，安装在这个设备上的微处理器是600 MHz的EP80579英特尔处理器。

在GEH-6725指令指南的第22页上，有一个小表格，标记了为is420ucsh1a供电所需的电气/电源额定值，额定值如下，小电压为18直流，大直流电为30伏，标称额定值为24伏和28伏直流电。该器件使用的大额定电流为1.5 ADC。

安装时，需要在危险和非危险场所安装is420ucsh1a控制器。例如，当安装在ATEX Zone 2, Group IIC中时，需要的认证是UL DEMKO 12 ATEX 1114875X。所有关于安装在I类，2区，IIC组，无害和I类，2分区，组，A, B, C和D的控制器的认证都是相同的，这些位置的认证要求是UL E207685。

如果您对此控制器的价格，运输时间或维修价格有任何疑问，请联系AX Controls的销售部门了解有关这些选项的更多信息。

Product Description
The IS420UCSBH1A controller is the first of the UCSB controllers manufactured by General Electric as part of the Mark VIe Control Safety System Series.  This controller is similar to the UCSC controller and while it does not have the same hardware the software needed to operate this controller is nearly identical.  According to the GEH-6725 Mark VIe and Mark VIeS, Controls Equipment HazLoc Instruction Guide the IS420UCSBH1A controller is labeled as a Mark VIe, LS2100e, and EX2100e controller.  There is also a specific microprocessor used with this controller, the microprocessor installed in this device is the 600 MHz EP80579 Intel Processor. 

On page twenty-two of the GEH-6725 Instruction Guide, there is a small table that labels the electrical/power supply ratings needed to power the IS420UCSBH1A, the ratings are as follows, a minimum voltage of eighteen direct currents, with a maximum of thirty volts of direct current, the nominal power rating is twenty-four and twenty-eight volts of direct current.  The maximum current rating used with this device is 1.5 ADC. 

When being mounted there are several certifications that are required to mount the IS420UCSBH1A controller in hazardous and non-hazardous locations alike.  For example, when mounted in ATEX Zone 2, Group IIC, the certification needed is UL DEMKO 12 ATEX 1114875X.  All certifications regarding the controller being mounted in Class I, Zone 2, Group IIC, non-hazardous, and Class I, Division 2, Groups, A, B, C, and D are the same, the certification requirements for these locations are UL E207685. 

其他型号推荐：